Search Results for "setup-subversion"

Alternative firmware for ESP8266 with easy configuration using webUI, OTA updates, automation using timers or rules, expandability and entirely local control over MQTT, HTTP, Serial or KNX. Unless your Tasmota powered device exhibits a problem or you need to make use of a feature that is not available in the Tasmota version currently installed on your device, leave your device alone - it works so don't make unnecessary changes! If the release version (i.e., the master branch) exhibits...

Growlight facilitates management of all storage devices known to the Linux kernel, from hardware RAIDs to hybrid media to ramdisks to ZFS (indeed, Growlight was initially written to simplify ZFS on Linux). It understands the majority of partition and filesystem types, as well as both software and hardware RAID, LVM, and encrypted disks.

hidtouch is an input device driver supporting USB touchscreens that are not recognized by Linux as event devices but as regular HID devices. A few companion programs will ease the setup and calibration process.

CONECT is a software to design, setup, commission and test home and building-automation systems. It will support various bus systems such as EIB.

...The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results. The project will help you to connect any arduino motor shield or other H-Bridges to the controller because it is open source and the output pins can therefor be changed as you like. You can upload a better modified version and improove this article by contacting me. With some pin changes you can port this code to other arduino boards.