Search Results for "pid"

...The modules use 2-pin probes and drives them with 4 kHz square wave in order to avoid oxidating the probes. In my implementation I used these small water pumps from Conrad: http://www.conrad.hu/conrad.php?name=Products&pid=539090 The whole system is powered by a 12V / 4A SMPS.

Linux Driver and control program for the Antec H20 - 920 Series liquid coolers.

Program tworzony w ramach przedmiotu "Projekt Grupowy" na Politechnice Gdańskiej. Skład: inż. Adam Banaś inż. Maciej Gajdzica inż. Adam Lasota inż. Damian Pawlus inż. Włodzimierz Kaoka Opiekun projektu: mgr inż. Piotr Fiertek Celem projektu jest stworzenie środowiska symulacyjnego dla procesów termicznych zachodzących w pomieszczeniach. Integralną jego częścią jest implementacja algorytmów obliczeniowych na procesorach graficznych GPU przy użyciu standardów CUDA...

This is a simple command line tool to customize CP2103 USB to UART bridge controllers in home-grown hardware. VID, PID, product name string, serial number string, and release version of the device can be changed next to GPIO port modes.

This low cost project is a RC servo like position control of one or two geared motor(s) with a pot as angle feedback. You can send the arduino microcontroller a value from 0 to 1023 and the arduino will control the motor speed and direction to reach your target value. The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results. The project will help you to connect any arduino motor shield or other H-Bridges to the controller because it is open source and the output pins can therefor be changed as you like. ...