Search Results for "order"

...All of the code is built around the GNU GCC toolchain offered and maintained by ARM. The build requires version 5.3.1 20160307 or newer of ARM GCC and will print an error message if the version is older than this. In order to turn your source code into binaries, you will need a tool called make. Windows users need to explicitly install make on their machines. Make sure you can use it from the terminal window. The entire Particle firmware is contained in this repository. The main user code sits in the application.cpp file under firmware/user/src/ folder. ...

The program ttylog is a serial port logger which can be used to print everything that comes in to a serial device to stdout. The device and the baud rate can be specified on the command line and a timeout can be set instead of just killing the process in order to stop it. You can also elect to have the output being sent to standard out to be time stamped.

... * Soil Moisure Sensors are responsible for sensing if the soil of irrigated flowers are wet or not. These sensors are attached to the Sensor Controller Module via slow speed I2C bus. The modules use 2-pin probes and drives them with 4 kHz square wave in order to avoid oxidating the probes. In my implementation I used these small water pumps from Conrad: http://www.conrad.hu/conrad.php?name=Products&pid=539090 The whole system is powered by a 12V / 4A SMPS.

Modern rotational hard disks have a misfeature involving the regular automatic unloading of the heads, measurable by the SMART attribute "Load_Cycle_Count", that causes latency on wake-up, and while the manufacturers sell this as "green", it is believed to cause reduced hard disk life. The parkverbot daemon will periodically issue small read requests in order to keep the hardware from going to its head-unloaded idle state.

sane-troubleshoot is a GUI program for linux that diagnoses problems with an installation of sane (scanner access now easy) the api for scanners. originally written by Henning Geinitz, there has been no development since 2005. This project takes up development in order to make sane-troubleshoot work on recent distros, and add new functions.

The project's main goal is to create a component, capable of being added to Freesacle's Codewarrior environment with XBee stack, in order for adding a complete implementation of the ADS1115 functionalities to Digi's XBee radios

FoxController is a cross-platform application wich allows to control etherogeneous devices through a general pupose web service interface. FoxController uses a plug-in architecture in order to implement the low level communication with the devices

A daemon to automatically control the fan speed of Thinkpad laptops using the ThinkPad ACPI Extras Driver in order to minimize noise pollution and extend battery life.

Provide a Linux driver and application in order to allow satellite Internet users the use of their favorite Operating system.

lptcap32 is intended to upgrade the 16-bit DOS-compatible "lptcap" software originally written by Kris Heidenstrom to 32-bit Linux compatibility in order to create a data-capture interface suitable for use within Point-Of-Sale enabled gasoline pumps.