Search Results for "setup-subversion"

...Keep your passwords and sensitive data secure with TLS encryption. Key, mouse and data all sent fast and securely, directly over your local network. Advanced customization settings give you complete control of your setup. The next version is being built from the ground up by combining the latest technologies, Node.js and React, with the rock-solid stability of C++.

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards. The web interface files are present in the data directory but UI has its own repository ESP3D-WEBUI. Use GPIO2 to the ground to reset all settings in a hard way, 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. ...

...A large range of serial boards (as well as usb boards that present as serial devices) are able to be controlled. KMTronic's USB and Serial relay boards are selectable in the configuration menu, other boards can be setup by entering their control commands. Although primarily designed for irrigation you can use AIC to control a large variety of hardware, for example lighting, heating etc It is envisaged that future implementations of AIC will incorporate rules for more complex device control.

... - Support class for SLE4432 / SLE4442 / SLE4441 and SLE4440 compatible sychron smartcards. Mostly used for secure data storage. Open points: - Error handling not completly implemented. No retries if parity error is found. - Setup of communication parameters from ATR - T=1 communication not supported (Still possible via "raw" sendBytes(..) / receiveBytes(..))

This project is no longer active or maintained. The Linux Printer Setup is a CUPS and Qt based tool to offer an easy to use alternative to the standard and much more complex KDE print setup utility. It shall bring more compfort and usability onto the KDE

...The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results. The project will help you to connect any arduino motor shield or other H-Bridges to the controller because it is open source and the output pins can therefor be changed as you like. You can upload a better modified version and improove this article by contacting me. With some pin changes you can port this code to other arduino boards.