Search Results for "connection"

This firmware allows not only to have a cheap bridge between Wifi and serial, but also to have a web UI to configure wifi, to monitor 3D printer and even control it, and to make things easy, UI is fully customizable without reflashing FW. Firmware should work with any 3D printer firmware (repetier/marlin/smoothie ware using GCODE) if the serial connection has a correct setup. I currently use it with my personal flavor of repetier for Due based boards. The web interface files are present in the data directory but UI has its own repository ESP3D-WEBUI. Use GPIO2 to the ground to reset all settings in a hard way, 2-6 sec after boot / not before!! Set GPIO2 to ground before boot change boot mode and go to special boot that do not reach FW. ...

...Hardware can connect to Blynk Cloud (open-source server) over the Internet using hardware connectivity available on your board (like ESP32), or with the use of various shields (Ethernet, WiFi, GSM, LTE, etc). Blynk Cloud is available for every user of Blynk for free. Direct connection over Bluetooth is also possible. Check the included examples on how to use different types of connections (transports) and explore Blynk features.

Linux driver for the Xbox One wireless dongle. xow is a Linux user mode driver for the Xbox One wireless dongle. It communicates with the dongle via libusb and provides joystick input through the uinput kernel module. The input mapping is based on existing kernel drivers like xpad.

GXGPRS offers an easy way to send data using GPRS connection. General Packet Radio Service (GPRS) enabled networks offer always-on, high capacity, Internet based content and packet based data services.

UbuDSL is a tool that helps users to configure their ADSL modem and connection under Ubuntu (and most of Ubuntu-based) distributions. It supports USB ADSL modems working under the following drivers: ueagle-atm, speedtch, cxacru, unicorn II.

This is a programmer software+hardware+firmware for Atmel AVR family (and more), using USB connection.

Monitoring/controlling tools and libraries for mCubed's T-Balancer family of devices. Connection is done via rs232 conversor port.

SoftDash PC allows realtime control of the Connect2Car MFC controller unit installed in a vehicle. Softdash PC can communicate with the MFC hardware either via a serial connection or a Bluetooth Connection. This project allows for open ended expansion.

Eppnics: Electronic parallel port network interfaced control system. Eppnics allows you to control electronic circuits connected to a parallel port via a TCP/IP connection.

Simple UPS monitoring plugin for GKrellM. Uses NUT (Network UPS Tools) for UPS connection. Based on "GKrellM Belkin UPS Plugin".

A device server inteded for (but not limited to) use with 3D input devices (like dynasight, Polhemus FASTRAK, motionstar and the magellan spacemouse). Devices can be configured via a remote TCP connection. Device data is sent to registered clients via