Search Results for "board game source code"

This project represents a community-driven effort to provide an easy-to-build and easy-to-modify cartridge dumper. Completely stand-alone, does not need a PC to operate (unless for updating firmware). Easy to modify open-source code, write your own extensions and share them with others. Portable thanks to a battery. Modular design using mostly off-the-shelf components. Reads NES, Famicom and Family Basic cartridges including save. Supports Mapper 30/NESmaker and flashes INL NM30 boards....

This is a work in progress split-flap display. Each module can flip between 40 unique characters: letters, numbers, and a few symbols. Multiple modules fit perfectly alongside each other to build bigger displays. The primary design goal was to make something that's possible to fabricate at home in small or single quantities and can be customized and built by an intermediate hobbyist at a reasonable price. This meant using widely available materials and avoiding any tooling with a high...

This low cost project is a RC servo like position control of one or two geared motor(s) with a pot as angle feedback. You can send the arduino microcontroller a value from 0 to 1023 and the arduino will control the motor speed and direction to reach your target value. The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results. The...