Search Results for "onboard"

Betaflight is flight controller software (firmware) used to fly multi-rotor craft and fixed wing craft. This fork differs from Baseflight and Cleanflight in that it focuses on flight performance, leading-edge feature additions, and wide target support. Betaflight supports a wide range of flight controllers with at least an STM32F4 MCU. You can use nearly any piece of modern hardware out there. Full telemetry and high refresh rate for receivers, camera and VTX control, RGB LEDs, and much...

SmartKnob is an open‑source hardware/software hybrid rotary input device featuring software-configurable end-stops and virtual detents, facilitated by a brushless gimbal motor and magnetic encoder—offering programmable haptic feedback and a novel, tactile user interface. 240x240 round LCD ("GC9A01"), protected by 39.5mm watch glass on rotor. BLDC gimbal motor, with a hollow shaft for mechanically & electrically connecting the LCD. PCB flexure and SMD resistors used as strain gauges for press...

Firmware for robots made using OpenWRT router and open-robotics.ru hardware

The cc3 project provides software for embedded vision systems. Currently, the software runs on the CMUcam3 hardware platform, which is a NXP LPC2106-based board with an onboard CMOS camera and FIFO, MMC interface, serial UARTs, and servo controller.

The UniLog is a small onboard data logging device for rc models. It records stuff like current, voltage, rpm, height, airspeed... python-unilog is to retrieve the data and do what you want with it.