Search Results for "drive"

TTF-GDOS is a GDOS replacement that uses true type fonts as well as gem fonts. It is small, fast & efficient and can easily be used without a hard drive. It also incorporates features roughly equivalent to font-GDOS: - a caching system so you can use more fonts for a given amount of memory, - built in bezier functions This release includes ttf2gem, a utility program that creates accurate gem fonts from a true type font (new for 2.3) Using true type fonts gives you 3 big benefits: - you can choose from a vast range of true type fonts - true type fonts are scalable so you can have almost any size font you want - true type fonts need much less disk storage than typical gem printer fonts, so even on a low spec machine you can use lots of fonts. ...

...A Spectranet device (apart from being networking interface) contains 128kB of extra RAM that can be accessed even with the Spectranet firmware disabled. This project proposes a FID driver that exposes Spectranet's extra memory as a ramdisk to the CP/M Plus system. Changes in v1.1: keep floppy drive motor state (as set by CP/M) when paging in Spectranet RAM (to avoid motor jumps). Unfortunately, motor state is controlled by the same hardware register as +3's memory paging features! Changes in v1.2: Avoid using Spectranet RAM page 0 used by the device itself. Thanks to this change this driver can be used with the upcoming driver for networked disk image. ...

CP/M Plus on ZX Spectrum +3 has ability to load device drivers from normal disk files (with .fid extension) on boot. One of the most important devices for any disk operating system is the mass storage drive. Although ZXMMC device is available on the market for years and it works well with +3e firmware, partitions created on MMC cards could not be accessed from CP/M world. At some point it became so frustrating, I decided to write FID driver for it. It's not perfect, but it works surprisingly well. For list of limitations, build instructions and more details see the source code file.

Roundhouse is a pair of C based embedded software applications to drive model railroad stepper motor based turntables. It consists of a stepper motor code and controller code connected by an I2C network. Written in C for PIC18/PIC16s processors.

Project purpose: emulating a disk drive which information will be stored in a database through network.

DVD/CD UDF disc drive tools, esp. for the Iomega RRD (aka Iomega REV) drive. Usability patches for UDF mkfs and fsck. Commentary for the lk MMC and UDF source code. cvs co tarballs for firewalls that defeat CVS. Links, FAQ's, troubleshooting hints.

Software to drive a Laser Tag gun and pack and other functions there in