Search Results for "flash program for stm32"

Open source cross platform flash program for the STM32 ARM microcontrollers using the built-in ST serial bootloader over UART or I2C

OpenBLT is mostly used as an STM32 bootloader, due to the popularity of STM32 microcontrollers. However, the bootloader’s architecture is such that it can work with any microcontroller and use any type of communication interface to perform firmware updates.

pFFh is a programming language that allows you to launch applications on embedded systems safely, quickly and comfortably. pFFh runs on the target system, combining operation as a command interpreter and code compiler. We can say that pFFh behaves like an operating system on the board under development. All pFFh needs is a serial or USB-serial channel to communicate, and through it, receive and process console commands, either from a keyboard or from files sent from a desktop computer. At...

SUSFinder is a utility to assign IP address and flash firmware to ASUS WL-500G Premium router booted in recovery mode on local network, in the case that you didn't know router's IP address settings beforehand. This utility do essentially the same thing as ASUS Firmware Restoration Utility, except that it relies on the external 'atftp' program to do the TFTP firmware flashing part.

FlashProg is USB base flash memory programmer which is specifically design to read and program 3.3V SPI flash memory devices.

This software supports programming of Atmel microcontrollers 89Sxx ('51), ATtiny, ATmega and 90Sxx (AVR). It can erase built-in Flash and EEPROM memories as well as read and program them. ISP Programmer also supports serial Atmel DataFlash memories.