Search Results for "8051 programmer linux"

EdSim51, developed by James Rogers, is unlike an industry-standard simulator – this simulator has the student in mind. A virtual 8051 is interfaced with virtual peripherals such as a keypad, motor, display, UART, etc. The student can write 8051 assembly code, step through the code and observe the effects each line has on the internal memory and the external peripherals. Code written in C can also be imported into the simulator. Find out more, including the installation instructions...

...Software to support these interfaces This includes: - Plugins to work with Freescale's Codewarrior software under Windows - Plugins to extend the usabilty of Eclipse with USBDM and Codesourcery & ARM toolchains. This includes GDB sprites providing a complete open source development toolchain. - A set of stand-alone programmer applications. These support programming of RS08, HCS08, HCS12, Coldfire and Kinetis devices. Where applicable, the software is available for Windows and Linux.

pFFh is a programming language that allows you to launch applications on embedded systems safely, quickly and comfortably. pFFh runs on the target system, combining operation as a command interpreter and code compiler. We can say that pFFh behaves like an operating system on the board under development. All pFFh needs is a serial or USB-serial channel to communicate, and through it, receive and process console commands, either from a keyboard or from files sent from a desktop computer. At...

P89 Serial Programmer (p89pgm) is a simple command-line based serial In-System Programmer for Philips (NXP) P89V51RD2 microcontroller. This programmer is designed to be minimal, and has no external software dependency. Supported input formats are Intel HEX and raw binary file. This programmer is designed for GNU/Linux and Unix-like platforms; but it also runs on Microsoft Windows as well, thanks to Cygwin porting library.

PK2Aux is a library and suite of command-line utilities for using the Microchip PICkit2 programmer device for purposes other than programming (such as the generic pin controls, serial UART, and logic analyzer modes provided by the Windows software).

FlashProg is USB base flash memory programmer which is specifically design to read and program 3.3V SPI flash memory devices.

The GoodFET is an open source JTAG programmer based upon the Texas Instruments Flash Emulation Tool. While retaining partial compatibility with the TI design, the eventual goal of this project is standalone firmware with no proprietary components.

Library and command line program providing access to the EEPROM of an Silabs CP2101 / CP2102 / CP2103. It can programm the USB-Descriptors and the Baudrate table.

This project is about enhancing user experience in wireless 802.15.4 chips through open source programmer, bootloader, flashing over the air, and viral flashing over WSN. Current development is done over CC2430 and STM32.

The Dragon Fire compiler takes a new, 21st century, look at the Dragon (i.e. Dragon Book). No longer impenetrable to the programmer, this compiler is open and available to them. You control the Dragon, and get Dragon insight into your programs.

Simple serial (SPI) programmer for small AVR MCUs written in C++ with Qt4 for Linux. PC interface is compatible with RS-232. HW consist of just a few transistors, resistors and diodes. SW is highly modular and quite simple to understand. Good luck !

TinyOS for 8051 based platforms such as Texas Instruments CC2430, Nordic Semi nRF24e1 and SiLab c8051F34x.