Search Results for "linux command"

Delve is a debugger for the Go programming language. The goal of the project is to provide a simple, full featured debugging tool for Go. Delve should be easy to invoke and easy to use. Chances are if you're using a debugger, things aren't going your way. With that in mind, Delve should stay out of your way as much as possible. Delve aims to be a very simple and powerful tool, but can be confusing if you're not used to using a source level debugger in a compiled language. This document will...

git-bug is fully embedded in git, you only need your git repository to have a bug tracker. git-bug is distributed. Use your normal git remote to collaborate, push and pull your bugs! git-bug works offline, in a plane or under the sea? Keep reading and writing bugs! It prevents vendor lock-in: your usual service is down or went bad? You already have a full backup. It is fast, listing bugs or opening them is a matter of milliseconds. git-bug doesn't pollute your project, no files are added in...

GAPID is a developer tool for recording and inspecting calls made by an application to the graphics driver. Once a capture of a target application has been made, GAPID lets you disconnect from the target and inspect all the graphics commands made by the application. GAPID is able to replay the command stream, letting you visualize the frame composition by stepping through each command and inspecting the driver state at any point in the stream. Replay also supports modifications, allowing you...