Search Results for "serial"

ParTools allows the interactive analysis of a C program execution profile and data dependencies to facilitate the discovery and selection of suitable parallelization candidates in a manual parallelization process. The flow does not assume any specific parallelization technique, thus it can be broadly applied. The original (serial) C source is automatically annotated to trace the execution profile and data dependencies at run-time. The annotated program is then executed using a significant (but small) data set selected by the developer. The data collected is cross-referenced with the original source and can be interactively analyzed graphically to determine the best parallelization candidates and techniques.

...To observe objects (in general spatial points) continuous, HEIMDALL’s programmable logic arrays can be used to design monitoring systems. For data analysis an interface to the least-squares program JAG3D can be provided. The serial communication with e.g. inclination sensors, meteorological stations or total stations is handled by the library RXTX. If only a proprietary communication via dynamic-link library (dll are not shared by the project) is supported by the devices, JNA is resorted. Notice, HEIMDALL is not a stand-alone monitoring application. It is only a set of libraries.

Virtual instrumentation software, currently designed for modifying automobile engines. Intended as a modular framework to communicate with devices on an IO port (serial, parallel etc.) and allow a visual representation of the instrument.

Recon allows monitoring and recording of data stream trough serial port.

ADCViewer visualizes analog signals coming from a microcontroller board through the serial port.

Simple VA18B multimeter interface. It reads data trasmitted by USB/Serial interface of VA18B multimeter and can put them into a CSV file.