Search Results for "input-leap"

...In addition, the coupling between airflow and heat transfer and the effect of surface roughness on near wall flow are considered by this program, it can be used for engineering calculation of the friction drag and heat transfer coefficients on airfoil surface. RANSFOIL reads coordinates data from a 1D XYZ file which describes the grid points or control points on airfoil as only input, then outputs grid and solution files in 2D PLOT3D format to record grid coordinates and airflow data and a report file to show aerodynamic parameters.

Construct2D is a grid generator designed to create 2D grids for CFD computations on airfoils. The grids are generated in Plot3D format. The only required input file is the set of coordinates defining the airfoil geometry, using the same format as XFoil, the popular vortex-panel code for airfoil analysis. Construct2D can create grids with O topology (recommended for airfoils with a blunt trailing edge) or C topology (recommended for airfoils with a sharp trailing edge). Now available in version 2.0: hyperbolic grid generation to create higher quality grids in a fraction of the time compared to elliptic grid generation. ...