Search Results for "engineering"

A simple to use serial communication software for communicating with other serial, MCU and Arduino. The SoftIB Serial Communicator communicates with other Serial devices that use a simple asynchronous communication using only the RX and TX signals without any control signals. The application was developed based on the communication with microcontrollers, but it can be used in all other cases.

AVR beacon project utilizes a new approach to RF signal generation using SQDDS method (making RF signals directly from the software, based on a pre-calculated periodic bit-sequence). It is mainly used by the hamradio operators to set up various radio beacons for different purposes, mostly for radio waves propagation discoveries. CW (continious waves, Morze code) is a main modulation mode. Other modes like PSK and FSK are planned to implement in the future releases. User can enter any ASCII...

The läufer project was established in the summer of 1998 by students of engineering design of Darmstadt University of Technology and by students of industrial design of Darmstadt University of Applied Sciences. The development and realization of a pred

OpenWebServo is an Open Source Hardware and Software project. Its main goal is to develop a web-controlled servo system. The project includes web application, firmware and hardware design.

Common Hardware Recovery Solutions by Ukrainian-Russian network

A complete bootloader that can load both an AVR processor and a Xilinx FPGA using a DataFLASH device to store programs.

The Simple Software Radio peripheral project is dedicated to developing and supporting open source software defined radio software and hardware. The project places an emphasis on thorough documentation and elegant modular design.

The aim of this project is for a stand alone home automation control system which consists of hardware (main and remote networked controllers) and software to monitor and control various devices around your house including X10 (plus others).

Design and implementation of silicon and software for baseband processors conforming to IEEE wireless standards. Initial focus on WiMAX and WiFi.

M4DSP is a QRP (low power) hamradio digital signal processing (DSP) tranceiver using a comprehensive yet powerfull Cortex-M4 MCU from STMicroelectronics. The main goals are: low cost, low power consumption, IPhone-like size & weight, QRP CW RX & TX, SSB/AM/FM RX-only, digital modes by demand, GUI with TFT + touchscreen, waterfall spectrum, CAT communication link via low-speed USB, pure SDR-like mode via high-speed USB, one or more hamradio bands (160-10 m), optional support for general...