Search Results for "rgb led"

Betaflight is flight controller software (firmware) used to fly multi-rotor craft and fixed wing craft. This fork differs from Baseflight and Cleanflight in that it focuses on flight performance, leading-edge feature additions, and wide target support. Betaflight supports a wide range of flight controllers with at least an STM32F4 MCU. You can use nearly any piece of modern hardware out there. Full telemetry and high refresh rate for receivers, camera and VTX control, RGB LEDs, and much more...

If you do a search for model rocket electronic payload, you will see a lot of entries for medium to high power, large diameter rockets. These types of rockets are large, typically 80mm (3.1 inches) in diameter or larger. These rockets are flown in large open areas, often deserts and dry lake beds. These larger rockets also use larger propellants, typically in the High Power Rocketry (HPR) range of “H” and above impulse level. Not only do these motors require you to be certified in HPR, the...

Project: Icarus is a proof of concept model rocketry research project that brings several individual projects together into a single model rocketry research launch vehicle. This specific project includes an avionics payload, temperature sensors along the body, and a video camera. The sensors record the heat buildup inside the body tube as the solid rocket motor burns and fires the ejection charge. The sensors are placed in three different locations along the body tube to provide data on the...

TOISWITCH is a general-Purpose multi I/O-Server for ESP8266. Its build as an easy-to-use Web-GUI-based server for a range of smart home devices. Currently it supports the following types of devices -Power plugs and Power strips incl power measurement -Multicolor (RGB/RGBW/RGBWW) LED lamps incl gamma correction -Switches -Dimmers -Motion detectors -Motor controls -Sensors It has an easy-to-use web-interface to control the devices and configure them. It supports powerful...

This is the software i created for controlling my PC's power indicator. The indicator has been replaced with an Arduino controlled RGB led. Core Temp is required and the Arduino code requires the CMD Messenger library. This software is in beta, and not 100% completed yet.

Initially this project started as hobby to build a "cool" christmas LED decoration. The result was 175 RGB LED snowflake driven by a Raspberry Pi. Since the hardware prototype is finished it's time to share the software and documentation...

This is a RGB LED Pin-back Button controlled by an AVR Microcontroller.