Search Results for "python serial port extension"

cooling home automation with Arduino(C) and Raspberry(front-end, python). Arduino features: - control PC 4-pin fan with PWM; - measure temperature/humidity with DHT11/22; - adjust fan RPM depend on temperature; - console management; - MQTT serial output. front-end features: - data collection form serial port with MQTT - webUI with for sensors parameters

CP/M Plus on ZX Spectrum +3 has ability to load device drivers from normal disk files (with .fid extension) on boot. A Spectranet device brings networking abilities to the Spectrum computers. This driver allows connection to a remote disk image registered as N: and a remote character device (e.g. serial console) registered as SPCNET: (namely, one can type `DEVICE aux:=spcnet` to redirect AUX: to SPCNET: and use it as a serial port over ethernet).

sercd is an RFC 2217-compliant serial port redirector. It lets you share a serial port through a network. It is based on sredird. The RFC2217 protocol is an extension to telnet and allows changing communication port parameters.

ESP-01, the simplest USD 1.50.- ESP8266 gets a firmware that allows the user to control it by serial port. Therefore it can be used along with any terminal, computer or microcontroller, which is equipped with a serial port (or USB port) -) Connect / disconnect to WiFi and Flespi MQTT broker -) Publish messages -) Subscribe to topics / Unsubscribe from topics -) Read the messages received Furthermore a GUI is on developing process to demonstrate the use. Paypal donations are...

Contains a framework for Coldfire MCUs like 52254. The framework supports a Command Line Interface (CLI) that may work from Serial port, USB or ENET. The framework uses Processor Expert and IDE requirement is MCU Eclipse 10.4 from Freescale. Includes the FunkOS Realtime Operating System by Funkenstein Software Consulting, available at http://funkos.sourceforge.net Mainly it is a support package for the development board Perseus, but I have ported also the RTOS to MCF52233DEMO...

serialLCD is Arduino based open-source project. It contains ATmega8 with given firmware file & the arduino library. The ATmega8 can be replaced by ATmega168/328. ATmega8 uses its 8MHz internal oscillator to reduce hardware (atmega8 no-xtal bootloader is used). The arduino library uses SoftwareSerial internally to communicate ATmega8 via digital pin 6 (only for uno/duemilanove or clone with atmega8/168/328, not for mega & due). Only one wire simplex serial communication at baudrate 9600 is...

ATMEL ATMega1280 based powerful, multifunctional, reliable, expandable and extremely flexible hardware platform for home and industrial processes automation, robotic toys, security systems, education and enjoyment.

OM Open-source multimeter is a hobby project of mine which is intended to do a multimeter's job and measure volt,ampere,ohm,capacitance and ... . the features would be high precision,plotting,computer connectivity,and of course being open source.

GunStamp is a program which can be used where ever accurate timestamping of events are required. What it does, is to syncronize the computer clock to an external time source (a GPS) connected to a serial port, and then use this clock to timestamp events.