Search Results for "serial library"

This library implements the serial commands supported by the Celestron NexStar hand control (HC) and SkyWatcher/Orion SynScan HC. This applies to the Celestron: NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, CGE, CGEM etc. SkyWatcher: EQ5, HEQ5, EQ6 (Pro), AZ-EQ5 GT, AZ-EQ6 GT, EQ8 etc. and the corresponding Orion mounts.

This module implements the serial commands supported by the Celestron NexStar hand control (HC) and SkyWatcher/Orion SynScan HC. This applies to the Celestron: NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, CGE, CGEM etc. SkyWatcher: EQ5, HEQ5, EQ6 (Pro), AZ-EQ5 GT, AZ-EQ6 GT, EQ8 etc. and the corresponding Orion mounts. Communication to the hand control is 9600 bits/sec, no parity and one stop bit via the RS-232 port...

This INDIdriver interacts with a mount controller using the Skywatcher Protocol through a serial link. It can directly drive Skywatcher and similar mounts through a serial port after a conversion of signal levels (see EQDIRECT interface), or any other mount hardware which uses this protocol. This project is similar in its goal to the EQMOD/EQASCOM project, but for the Linux/INDI world. Thus the name of the INDI device is "EQMod Mount", and the driver executable is indi_eqmod_telescope. ***** Refer to the libindi library ***** The driver is now included in the libindi library as a 3rd party driver (indi-eqmod).