Search Results for "firmware"

A project by Clive Stachon, Pete I, Paul P and Robert Brown in modifying a manual 5 slot filter wheel to automatic using an Arduino Nano and stepper motor. Windows application, ASCOM driver and Arduino firmware provided. Updated, reflecting new PDF and firmware and applications based on contributions from Pete. Project supports 4, 5, 7 and 9 slot filterwheels.

...This code is for the direct-sampling input of the receiver, which transmits real samples over USB3 at up to 130 MHz sample rate. rx2fits processes these samples to spectral intensities via a Fourier-transform poly-phase filter bank, which provides spectral resolution approaching the spectral bin width with good stop-band and adjacent-channel rejection. Sample rate, Fourier bin count, PFB frame count, integration time and receiver gain parameters can be set. Utilities for device enumeration, firmware upload, display of FITS header, file viewing, and for measuring sample rate and sample statistics are provided. The device interface is Ruslan Migirow's librx888 and dropped samples at 130 MHz are negligible. Runs on linux computers under .Net.

This library implements the serial commands supported by the Celestron NexStar hand control (HC) and SkyWatcher/Orion SynScan HC. This applies to the Celestron: NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, CGE, CGEM etc. SkyWatcher: EQ5, HEQ5, EQ6 (Pro), AZ-EQ5 GT, AZ-EQ6 GT, EQ8 etc. and the corresponding Orion mounts. Communication to the hand control is 9600 bits/sec, no parity and one stop bit via the RS-232...

This module implements the serial commands supported by the Celestron NexStar hand control (HC) and SkyWatcher/Orion SynScan HC. This applies to the Celestron: NexStar GPS, NexStar GPS-SA, NexStar iSeries, NexStar SE Series, NexStar GT, CPC, SLT, Advanced-VX, Advanced-GT, CGE, CGEM etc. SkyWatcher: EQ5, HEQ5, EQ6 (Pro), AZ-EQ5 GT, AZ-EQ6 GT, EQ8 etc. and the corresponding Orion mounts. Communication to the hand control is 9600 bits/sec, no parity and one stop bit via the RS-232 port...

ASCOM driver for the LittleFoot Elegance Photo (LFEP) telescope controller. Firmware 6.x is fully supported - firmware 5.x is partially supported (all LFEP features are available but configuration is only possible by handbox). Contains drivers for telescope, focuser, camera, filter wheel, roof controller and dew heater which shares a single connection to the controller.

This project is a collection of DIY hardware devices aimed at astronomy, together with their firmwares and softwares. At this moment, it contains a PIC based mount motorization, built for an old EQ5-like mount. The firmware implements the Skywatcher protocol.