-
Thank you for your report. This problem has been fixed in v2_3_branch and master. The fix will be present in emc 2.3.4 when it is released.
2009-10-14 14:27:11 UTC in Enhanced Machine Controller
-
This is a bug in the gcode interpreter. Reassigned accordingly. It's probably another face of the behavior reported at http://mid.gmane.org/200907141504.55590.mb@bu3sch.de and replies
Run sim/tkemc.ini. Open example2 and run. You will get an error. Open example1 and run.
Expected behavior: example1 part program runs
Actual behavior: no motion.
2009-10-14 14:04:05 UTC in Enhanced Machine Controller
-
Fixed in master and v2_3_branch. thank you for your submission.
2009-10-14 13:54:55 UTC in Enhanced Machine Controller
-
fixed, thanks.
2009-09-01 17:45:45 UTC in Enhanced Machine Controller
-
With interp list debugging turned on, the last messages are as follows:
good:
NML_INTERP_LIST::append(nml_msg{size=116,type=EMC_TRAJ_PROBE}) : list_size=5, line_number=9
NML_INTERP_LIST::append(nml_msg{size=84,type=EMC_TRAJ_SET_OFFSET}) : list_size=6, line_number=9
NML_INTERP_LIST::append(nml_msg{size=116,type=EMC_TRAJ_LINEAR_MOVE}) : list_size=7, line_number=15
bad...
2009-08-31 20:41:47 UTC in Enhanced Machine Controller
-
How to reproduce:
1. Apply the attached patch, which sets up a simulated probe input that always trips at machine Z = -1inch
2. Run configs/sim/axis.ini
3. F1 F3 ctrl-home F5
4. twice: MDI O call
Expected behavior: moves to 50,50,-3 (mm)
Actual behavior: half the time, stops at 0,0,~0 (mm)
Debug trace from "good" iteration:
Issuing EMC_TASK_PLAN_EXECUTE -- (+509,+268...
2009-08-31 20:38:18 UTC in Enhanced Machine Controller
-
jepler changed the public information on the Enhanced Machine Controller project.
2009-08-31 16:19:25 UTC in Enhanced Machine Controller
-
jepler changed the public information on the Enhanced Machine Controller project.
2009-08-31 16:19:25 UTC in Enhanced Machine Controller
-
jepler changed the public information on the Enhanced Machine Controller project.
2009-08-31 16:19:20 UTC in Enhanced Machine Controller
-
jepler changed the public information on the Enhanced Machine Controller project.
2009-08-31 16:19:20 UTC in Enhanced Machine Controller
