Kawasaki USB to Ethernet Driver

I'm using a Compaq Presario 1200 laptop running FC3
(patched & latest 2.6 kernel. I'm using a Xircom
PortGear PGENET-10 USB NIC to connect.

My problem is that I have to plug and unplug a couple
of times in order to get the card to configure.

Once it is connect, it works fine.

Here's the output from dmesg:

usb 1-1: USB disconnect, address 2
usb 1-1: new full speed USB device using uhci_hcd and
address 3
drivers/usb/net/kaweth.c: Downloading firmware...
usb 1-1: 05-wait_for_sys timed out on ep0in
drivers/usb/net/kaweth.c: Error downloading trigger
code fix (-71)
kaweth: probe of 1-1:1.0 failed with error -5
usb 1-1: USB disconnect, address 3
usb 1-1: new full speed USB device using uhci_hcd and
address 4
drivers/usb/net/kaweth.c: Downloading firmware...
usb 1-1: 05-wait_for_sys timed out on ep0in
drivers/usb/net/kaweth.c: Firmware loaded. I'll be back...
kaweth: probe of 1-1:1.0 failed with error -5
usb 1-1: USB disconnect, address 4
usb 1-1: new full speed USB device using uhci_hcd and
address 5
drivers/usb/net/kaweth.c: Firmware present in device.
drivers/usb/net/kaweth.c: Statistics collection: 13fbffff
drivers/usb/net/kaweth.c: Multicast filter limit: 80
drivers/usb/net/kaweth.c: MTU: 1514
drivers/usb/net/kaweth.c: Read MAC address
00:10:a4:af:63:44
divert: allocating divert_blk for eth0
drivers/usb/net/kaweth.c: kaweth interface created at eth0
drivers/usb/net/kaweth.c: Failed to set Rx mode: -16
drivers/usb/net/kaweth.c: Failed to set Rx mode: -16
drivers/usb/net/kaweth.c: Failed to set Rx mode: -16

Here's the kernel.conf file:

###########################################################################

# $Id: kernel.conf,v 1.8 2002/10/13 02:01:51 kirk Exp $
###########################################################################


# You can put comments anywhere you want to. They are
effective for the
# rest of the line.

# this is in the format of <name> = <value>.
Whitespace at the beginning
# and end of the lines is removed. Whitespace before
and after the = sign
# is removed. Everything is case *insensitive*.

# Yes = True = On = 1
# No = False = Off = 0

Title = "Kernel"

# Which logfile group...
LogFile = messages

# Only give lines pertaining to the kernel service...
*OnlyService = kernel
*RemoveHeaders
*Remove = segfault
*Remove = locate module

# Set this to yes to lookup IPs in kernel firewall report
$kernel_ip_lookup = No

########################################################
# This was written and is maintained by:
# Kirk Bauer <kirk@kaybee.org>
#
# Please send all comments, suggestions, bug reports,
# etc, to kirk@kaybee.org.
########################################################