A simple SIP and RTP NAT friendly proxy for SIP based VoIP
Be the first to post a text review of SaRP. Rate and review a project by clicking thumbs up or thumbs down in the right column.
Changes to SaRP 0.3pre2 * v0.3pre1 was completely broken for making calls. This is now fixed. * Disabled 'pings' by default since at least one client stops responding after a few SIP packets. * When using 'pings' each UA gets it's own timer and CSeq. Changes to SaRP 0.3pre1 * SaRP now monitors SIP traffic from UAs involved in a call and if no traffic is seen then uses an OPTIONS packet as a sort of 'ping'. * default behaviour is now to daemonise. * default behaviour is now to log to $logfile (default is /var/log/sarp.log) * Some code cleanup Changes to SaRP 0.2.1 * Fixed the port used for sending datat back to the requesting UA * Added bandwidth usage to report at end of RTP proxy. * Cleaned up the adding and deleting of alarms * Changed the printing of messages to support a 'verbosity' level Changes to SaRP 0.2 * Added a config file (only works on *nix like machines). * Should run on Windows just fine. * Added alarms so that events can now happen at set times. * LOTS of clean up of the code. Changes to SaRP 0.1 * Initial release
Changes to SaRP 0.3pre2 * v0.3pre1 was completely broken for making calls. This is now fixed. * Disabled 'pings' by default since at least one client stops responding after a few SIP packets. * When using 'pings' each UA gets it's own timer and CSeq. Changes to SaRP 0.3pre1 * SaRP now monitors SIP traffic from UAs involved in a call and if no traffic is seen then uses an OPTIONS packet as a sort of 'ping'. * default behaviour is now to daemonise. * default behaviour is now to log to $logfile (default is /var/log/sarp.log) * Some code cleanup Changes to SaRP 0.2.1 * Fixed the port used for sending datat back to the requesting UA * Added bandwidth usage to report at end of RTP proxy. * Cleaned up the adding and deleting of alarms * Changed the printing of messages to support a 'verbosity' level Changes to SaRP 0.2 * Added a config file (only works on *nix like machines). * Should run on Windows just fine. * Added alarms so that events can now happen at set times. * LOTS of clean up of the code. Changes to SaRP 0.1 * Initial release
Be the first person to add a text review.
Copyright © 2009 Geeknet, Inc. All rights reserved. Terms of Use
Thanks for your rating!
Would you also like to write a review?