Welcome, Guest! Log In | Create Account

Share

Broadcom replacement firmware

The forum address has changed, you have been automatically redirected. Please update any bookmarks to use the new URL.

Subscribe

ver 1 routernot working after firmware

Add A Reply

You are viewing a single message from this topic. View all messages.

  1. trakker123

    2004-08-03 20:47:08 UTC
    ok for all of you that get the ap broken after reflashing, reflash whit any other firmware and in a shell put this

    nvram set lan_ifnames="vlan0 eth0 eth2 eth3"
    nvram set wan_ifnames="eth1"
    nvram set wan_ifname="eth1"

    nvram commit
    reboot

    After that reconfigure the AP and dont restore the default setting or your AP will be broken again.
< Previous | 1 | Next >

Add a Reply

This forum does not allow anonymous participation.

Log in to add a reply. Not registered? Create an account to participate and receive email updates when replies are posted to this topic.

About SourceForge

Find Software

Develop Software

Community

Help

Copyright © 2009 Geeknet, Inc. All rights reserved. Terms of Use