-
It seems that spandsp (looking at 0.0.5) has support for several data modes now - How easy would it be to get data mode support into iaxmodem? Looking here: http://www.soft-switch.org/spandsp-modules.html
There are modules for V.8 negotiation, V.21 (needed for V.8), V.22bis (1200/2400 support), V.42/42bis plus a bunch of other higher speeds. Personally I'm just looking at V.22bis...
2009-11-04 18:48:19 UTC by bozzaj
-
In your iaxmodem config file set refresh to 0.
2009-10-27 03:32:09 UTC by faxguy
-
Hi,
is there a way to run iaxmodem together with FreeSWITCH?
FS currently supports iax only without registration.
Thanks, Klaus.
2009-10-26 09:36:28 UTC by hochlehnert
-
c000000075 indicates that the sender cannot hear your CFR signal (training succeeded). Again, it looks like there are audio problems going from you to the sender.
2009-10-05 03:02:37 UTC by faxguy
-
done.
2009-10-02 08:18:22 UTC by gzieleman
-
I've never used Asterisk 1.6. Maybe you should try with 1.4.
2009-10-02 03:40:41 UTC by faxguy
-
please change the permissions on c000000075.
2009-09-30 15:16:02 UTC by faxguy
-
did a new test , i posted new sound and new log, still does not work, what can it be.
2009-09-30 14:58:56 UTC by gzieleman
-
If you listen to testfax-iax.raw corresponding to c000000068 you will see that there is no fax audio there. The problem with c000000069 is that the sender does not hear your MCF signal... even after three attempts. So something was wrong with the audio going back from you to the sender at that point.
2009-09-30 14:33:19 UTC by faxguy
-
audio belongs to 00000068 , and that one got an error 106 , then same fax comes in ( 00000069) but keeps repeating 5 times, so i've got 5 tif files.
2009-09-30 07:59:22 UTC by gzieleman
