-
I managed to get the build system to build the basic image by chrooting the gutsy distribution (7.10). It's an ugly solution but it works. I added a page to the user wiki describing how to do this.
2009-11-13 18:46:48 UTC by cheshirekow
-
I think this may be due to using a newer version of GCC than is intended for compilation. I have version 4.4.1 installed with Ubuntu. Which version should I have for use with the gumstix openembedded?.
2009-11-13 04:26:53 UTC by cheshirekow
-
On Ubuntu 9.10, following the instructions provided at "http://www.gumstix.net/Setup-and-Programming/view/Getting-started/Setting-up-a-build-environment/111.html" building a basic image fails. I will attempt to include the relevant details from the output.
Failure occurs during "Running task 104 of 1391 (ID: 314, /home/.../packages/binutils/binutils-cross_2.18.bb, do_compile)"
The error says...
2009-11-13 04:05:09 UTC by cheshirekow
-
The signals defined for J4 are correctly labeled:
http://www.gumstix.net/Hardware/view/I/O-connectors-cabling/Gumstix-Overo-70-pin-connector-J4-features-Extended-Memory-Bus-and-MMC-signals/112.html.
2009-11-12 17:58:27 UTC by donnay
-
Link now found at:
http://www.gumstix.net/User-How-To-s/view/Build-system-overview/Hello-world-tutorial/110.html.
2009-11-12 17:55:01 UTC by donnay
-
PNG-format layouts are available for all boards at pubs.gumstix.com eg for the Tobi board:
http://pubs.gumstix.com/boards/TOBI/PCB30002-R2411/.
2009-11-12 17:29:38 UTC by donnay
-
This page is no longer valid. The 70-pin connectors on each Overo COM are J1 and J4. Pinouts for these connectors are defined here:
http://www.gumstix.net/Hardware/cat/I/O-connectors-cabling/112.html.
2009-11-12 17:26:38 UTC by donnay
-
Sorry, but do not see this link on that Overo Setup and Programming page at www.gumstix.net.
The postings about OE at BEC Systems can be found here:
http://bec-systems.com/site/tag/openembedded.
2009-11-12 17:23:04 UTC by donnay
-
The 40-pin header SV1 is common to several Gumstix Overo expansion boards: Summit, Tobi, Palo, Chestnut boards.
Documentation at www.gumstix.net has been updated to correct any mistakes, as identified here.
2009-11-12 17:14:38 UTC by donnay
-
corrected. 11/12/09 DmA.
2009-11-12 16:16:04 UTC by donnay
