From: Thomas Lassmann <tlassmann@it...> - 2004-04-21 16:13:55
I try to compile mysql, and always get diffrent Assembler messages:
Error something. And the compiler stops.
On my host the same source compiles fine with the same CFLAGS.
So my question is: Do I need diffrent CFLAGS for my UML. And if I do,
which CFLAGS should I use.
I got a Intel(R) Celeron(R) CPU 2.40GHz.
And my UML has the skas mode enabled.
My CFLAGS are: CFLAGS="-march=pentium4 -O2 -pipe -fomit-frame-pointer"
Alle 18:13, mercoled=EC 21 aprile 2004, Thomas Lassmann ha scritto:
> I try to compile mysql, and always get diffrent Assembler messages:
> Error something. And the compiler stops.
Well, I'm a wizard so I can guess your error message, but I'm not able to=20
solve your problem because I'm not a computer expert - while there are UML=
experts here which are not wizards :-).
Seriously speaking, post the compilation output or you'll get ignored.
> On my host the same source compiles fine with the same CFLAGS.
> So my question is: Do I need diffrent CFLAGS for my UML. And if I do,
> which CFLAGS should I use.
This question is clear, but the answer is NO. You could as well build your=
mysql on the host and try to run it onto the guest - the only problems are =
there are libraries mismatch, as every time you move a binary from one dist=
onto another. Make sure you have installed all the development packages whi=
are needed. And state your host/guest Distros and the gcc, and libc version=
of both, please (which root_fs you are using may also be useful).
> I got a Intel(R) Celeron(R) CPU 2.40GHz.
> And my UML has the skas mode enabled.
> My CFLAGS are: CFLAGS=3D"-march=3Dpentium4 -O2 -pipe -fomit-frame-pointer"
Paolo Giarrusso, aka Blaisorblade
Linux registered user n. 292729