From: Gopalakrishnan A.N <sa...@gm...> - 2011-02-28 13:34:58
|
Still I am struggling to register the basic script... let me take the wireshark log... On Fri, Feb 25, 2011 at 4:10 PM, mayamatakeshi <may...@gm...>wrote: > > > On Fri, Feb 25, 2011 at 7:27 PM, Gopalakrishnan A.N <sa...@gm...>wrote: > >> I will check with wireshark tool as well. and moreover in the xml file you >> have mentioned some noop tag by assigning values and assigning strings. >> Actually what is the use of that, > > > They are used to keep re-registering using the same "call" (in SIPp terms) > by incrementing the value of CSeq. > > >> do we really required? > > > No. You can remove them. > > But to do it, please read > http://sipp.sourceforge.net/doc3.0/reference.html > > You will be able to do any meaningful work without reading the docs. > > >> >> On Thu, Feb 24, 2011 at 6:06 PM, mayamatakeshi <may...@gm...>wrote: >> >>> >>> >>> On Thu, Feb 24, 2011 at 9:30 PM, Gopalakrishnan A.N <sa...@gm...>wrote: >>> >>>> Thanks for your reply. I will try with single call. and moreover i am >>>> testing with trixbox and already I have some configured IP extensions, can I >>>> use those extensions in data.txt file? >>> >>> >>> Yes. >>> The injection file must contain valid data. Do not use the sample data >>> that was presented in the xml file. >>> >>> >>>> >>>> >>>> On Thu, Feb 24, 2011 at 8:46 AM, mayamatakeshi <may...@gm... >>>> > wrote: >>>> >>>>> >>>>> >>>>> On Thu, Feb 24, 2011 at 1:25 AM, Gopalakrishnan A.N <sa...@gm...>wrote: >>>>> >>>>>> I did the installation it was perfect. while executing the sipp with >>>>>> the following command >>>>>> >>>>>> ./sipp -i 192.168.0.75 -p 6060 -sf register.xml -inf data.txt -d 20000 >>>>>> 192.168.0.63 -trace_err >>>>>> >>>>> >>>>> Before testing with load, try a single call using "-m 1" and make sure >>>>> the scenario runs without problems. >>>>> If it doesn't, then get a packet capture of a single call and it will >>>>> clearly show where the problem is. >>>>> >>>>> From your log, Asterisk is just sending "404 Not Found" instead of >>>>> requiring authentication so this is an issue with your Asterisk >>>>> configuration. >>>>> >>>>> >>>>>> >>>>>> I get dead calls and aborted message. some thing related to 407 proxy >>>>>> authentication, does it really required in the registration process. >>>>>> >>>>> >>>>> The scenario is prepared to accept 401 or 407 (so that it can be used >>>>> with servers that use one or another). >>>>> >>>>> >>>> >>>> >>>> -- >>>> Thank you with regards, >>>> Gopalakrishnan A.N. >>>> VoIP call - sip:sa...@gt... >>>> >>>> >>>> >>> >> >> >> -- >> Thank you with regards, >> Gopalakrishnan A.N. >> VoIP call - sip:sa...@gt... >> >> >> > -- Thank you with regards, Gopalakrishnan A.N. VoIP call - sip:sa...@gt... |