[reprap-commits] SF.net SVN: reprap:[3814] trunk/software/firmware/FiveD_GCode/ FiveD_GCode_Interpreter/configuration.h.dist

[<adr...@us...>]

Revision: 3814
          http://reprap.svn.sourceforge.net/reprap/?rev=3814&view=rev
Author:   adrian-bowyer
Date:     2010-09-28 23:38:55 +0000 (Tue, 28 Sep 2010)

Log Message:
-----------
Added new pulley teeth numbers to the firmware configuration file (affects steps/mm).

Modified Paths:
--------------
    trunk/software/firmware/FiveD_GCode/FiveD_GCode_Interpreter/configuration.h.dist

Modified: trunk/software/firmware/FiveD_GCode/FiveD_GCode_Interpreter/configuration.h.dist
===================================================================
--- trunk/software/firmware/FiveD_GCode/FiveD_GCode_Interpreter/configuration.h.dist	2010-09-28 23:31:07 UTC (rev 3813)
+++ trunk/software/firmware/FiveD_GCode/FiveD_GCode_Interpreter/configuration.h.dist	2010-09-28 23:38:55 UTC (rev 3814)
@@ -176,19 +176,25 @@
 
 // Axis scaling in stepper-motor steps per mm of movement
 
-// The second set of commented out values are for the new 13-tooth pulley: pulley_7_9-5_13_7
+// The first set of values are for the original 8-toothed pulleys
+// The second set of commented out values are for the new 9-tooth pulley: set-screw-drive-pulley_4_6-5_9_7_3off
+// The third set of commented out values are for the 13-tooted pulleys set-screw-drive-pulley_7_9-5_13_7-3off.stl
+// See mendel/mechanics/solid-models/cartesian-robot-m4/printed-parts/alternative-parts/readme
 
 #define X_STEPS_PER_MM   80.376
+//#define X_STEPS_PER_MM   71.445
 //#define X_STEPS_PER_MM   49.462
 #define X_STEPS_PER_INCH (X_STEPS_PER_MM*INCHES_TO_MM) // *RO
 #define INVERT_X_DIR 0
 
 #define Y_STEPS_PER_MM   80.376
-//#define X_STEPS_PER_MM   49.462
+//#define Y_STEPS_PER_MM   71.445
+//#define Y_STEPS_PER_MM   49.462
 #define Y_STEPS_PER_INCH (Y_STEPS_PER_MM*INCHES_TO_MM) // *RO
 #define INVERT_Y_DIR 0
 
 #define Z_STEPS_PER_MM   6667.184
+//#define Z_STEPS_PER_MM   5926.386
 //#define Z_STEPS_PER_MM   4102.882
 #define Z_STEPS_PER_INCH (Z_STEPS_PER_MM*INCHES_TO_MM) // *RO
 #define INVERT_Z_DIR 1


This was sent by the SourceForge.net collaborative development platform, the world's largest Open Source development site.