From: Mike Asker <mike.asker@at...> - 2008-09-18 21:37:52
If I run an AC sim of a simple circuit
and I have an equation v = yvalue(op.v, 1e6)
I can then display the result in a table,
and this works OK.
However if I try to do a parameter sweep
of the same circuit, the simulation runs but
my equation gives the following error:
" evaluation exception stack
006: not an appropriate dependent data vector"
I expected to see the equation results listed in the table
one per sweep in the table.
It seems that the equation cannot reference a signal result
if used with a parameter sweep AC sim. Is this a bug?
I am using qucs v0.14 on a Windows(XP)