DXF Engraving resolution of radii

Help
2013-06-17
2013-06-17
  • George Comber
    George Comber
    2013-06-17

    Hi,
    I have just started using Pycam on a router for cutting shapes from plastic and have been importing DXF's. I was wondering if there is a way of increasing the resolution on corners- it seems to give 8 straight lines per quarter circle which is fine on small holes but comes out as quite large straights on a, say, 40mm radius. Is it getting this from the DXF? I don't think so as I think the DXF has them in as curves. A means of setting the length of the straights would be excellent as this would work for all sizes of rad. Any help?

     
  • George Comber
    George Comber
    2013-06-17

    Apologies, I see that this has been answers in thread "Circle Segments".
    Is it possible to change the default number of segments in the standalone windows version.
    Thanks.