The same STL surface mesh is handled by the netgen surface meshing correctly in revision 265 but crashes in revision 356. The only way to avoid the crash is inversion of the surface orientation. Volume meshing, however, still requires the same orientation. Has the required surface orientation changed between the revisions?
PS. I am using just the library, not the whole application.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
The same STL surface mesh is handled by the netgen surface meshing correctly in revision 265 but crashes in revision 356. The only way to avoid the crash is inversion of the surface orientation. Volume meshing, however, still requires the same orientation. Has the required surface orientation changed between the revisions?
PS. I am using just the library, not the whole application.