Re: [Ndiswrapper-general] how to get "monitor" mode in ndiswrapper?
Status: Beta
Brought to you by:
pgiri
From: John H. <mis...@gm...> - 2006-11-21 16:33:17
|
Ok, so what module do I use at that point? 43xx? On 11/21/06, Larry Finger <Lar...@lw...> wrote: > John H. wrote: > > 0b:00.0 0280: 14e4:4311 (rev 01) > > > > > > On 11/21/06, Larry Finger <Lar...@lw...> wrote: > >> John H. wrote: > >>> 0b:00.0 Network controller: Broadcom Corporation Dell Wireless 1390 > >>> WLAN Mini-PCI Card (rev 01) > >>> Subsystem: Dell Unknown device 0007 > >>> Flags: bus master, fast devsel, latency 0, IRQ 169 > >>> Memory at dfdfc000 (32-bit, non-prefetchable) [size=16K] > >>> Capabilities: <access denied> > >>> > >>> > >> Dell really gets in there deeply. What does 'lspci -n' show for bus 0b:00.0? > > Ahh, it is a 4311. That is a PCI-E device. Support for that is in the 2.6.19-rcX series of kernels. > I also have a patch to add that code to a 2.6.18.Y kernel available at > ftp://lwfinger.dynalias.org/patches. The device is not supported in earlier kernels. > > Larry > > |