Re: [Mspgcc-users] msp430-gcc using wrong assembler..

[Andy W. <an...@po...>]

On Tue, Nov 22, 2011 at 10:31 AM, Sergio Campamá <ser...@gm...>wrote:

> Just follow the guide on the wiki link I posted earlier (which BTW is VERY
> hard to find in the wiki if you don't know the address)
>
> It just works, like a Mac
>

I agree the wiki link is non-obvious, and I do thank you, Sergio for your
page, which was helpful.

I had a slightly different problem from Chad, but I was following those
instructions, for some unknown reason binutils install on my system didn't
quite finish the job, and then gcc configure didn't figure things out
correctly.

As I said, I think this may be because of the crud left behind from
previous installs of msp430 tools. I don't understand why it happened, as
I've never seen this problem before (and I've built/installed cross-gcc
many, many times.)
-- 
Andy