Hi guys!

First of all thank you for amazing peace!

I am trying to run motion on FreeBSD 9.0

Did check out from svn motion 3.2

Configure, gmake, gmake install - everything is perfect.

My webcam is Logitech C250 (Logitech C270 being reported as working out of the box http://www.lavrsen.dk/foswiki/bin/view/Motion/Logitech#Logitech_C270_40720p_41)

To create webcam device i use /usr/ports/multimedia/webcamd/ and /usr/ports/multimedia/pwcview/ works perfect, but not motion.

It seems that motion does not recognize the device ? Is that correct ? Log is below.

[0] Motion 3.2.12 Started
[0] ffmpeg LIBAVCODEC_BUILD 3439360 LIBAVFORMAT_BUILD 3436288
[0] Thread 1 is from ../etc/motion-dist.conf
[1] Thread 1 started
[1] vid_start: [/dev/video0]
[0] motion-httpd/3.2.12 running, accepting connections
[0] motion-httpd: waiting for data on port TCP 8080
[1] set_input: Channel Port 65535 out of range (0-4)
[1] v4l_start: set input [65535]
[1] Could not fetch initial image from camera
[1] Motion continues using width and height from config file(s)
[1] Resizing pre_capture buffer to 1 items
[1] Started stream webcam server in port 8081
[1] Retrying until successful connection with camera
[1] vid_start: [/dev/video0]
[1] set_input: Channel Port 65535 out of range (0-4)
[1] v4l_start: set input [65535]
[1] Retrying until successful connection with camera
[1] vid_start: [/dev/video0]
[1] set_input: Channel Port 65535 out of range (0-4)
[1] v4l_start: set input [65535]
[1] Retrying until successful connection with camera
[1] vid_start: [/dev/video0]
[1] set_input: Channel Port 65535 out of range (0-4)
[1] v4l_start: set input [65535]
[1] Video signal lost - Adding grey image
[1] Retrying until successful connection with camera
[1] vid_start: [/dev/video0]
[1] set_input: Channel Port 65535 out of range (0-4)
[1] v4l_start: set input [65535]
^C[0] httpd - Finishing
[0] httpd Closing
[0] httpd thread exit
[1] Thread exiting
[0] Motion terminating

Thank You,
Karolis