From: Alan Womack <arwbackup@wo...> - 2002-03-26 15:13:33
The remote and my receiver are a few inches away from me while I test this all =
out. If I drop MH out of the loop:
RF Remote->BX24-AHT->CM11A, the heater works.
RF Remote->BX24-AHT->MH->CM11A, the heater does not work.
Since the log shows the proper item, I was surmising the problem must be =
something I did whilst playing. If the item shows in the log, mh should have =
caused a state change before/after it prints to the log?
It was working before I started playing with prepending "1:" to the cm11.pm, =
which I understand now why, didn't work out so well. :)
>> Sounds like an X10 signal quality issue. The CM11 is plugged into an
>> that can hear your x-10 remote, and can control your module, but maybe the
>> x-10 rf receiver is far enough away from the X10 module that it the signal
>> does not get through.
Epson Inkjet Printer FAQ: http://welcome.to/epson-inkjet