[misterhouse-users] test_x10 works, but mh gives checksum errors

[Holly J. S. <so...@mu...>]

Not sure if I sent an email out about this earlier, so I apologize if this
is a repeat :)

I've edited my mh.private.ini file so that serial1_port and cm11_port
point to /dev/ttyS0. The serial device has write permissions for
everyone. The test_x10 script in bin works fine with those
settings. However, when I try to run mh, it gives me:

Bad checksum in cm11 send: cs1=105 cs2=.  Will retry

Can someone suggest where to look for places to correct this?

-Holly