Is it possible to support one antenna for receive and one antenna
for transmit as follows:
echo 0 > /proc/sys/dev/wifi0/diversity --- put diversity off
echo 1 > /proc/sys/dev/wifi0/txantenna --- txantenna on connctor 1
echo 2 > /proc/sys/dev/wifi0/rxantenna -- rxantenna on connector 2
The issue observed with CM9_GP card is that rxnatenna follows
txnatenna after the interface is up.
i.e value of rxantenna changes from 2 to 1.
Hence is it possible to support txantenna on connector 1 and
rxantenna on connector 2??
Disclaimer : This message is proprietary to Smartlink Network Systems Limited and is intended solely for the use of the individual to whom it is addressed. It may contain privileged or confidential information and should not be circulated or used for any purpose other than for what it is intended. If you have received this message in error, please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly prohibited from using, copying, altering, or disclosing the contents of this message. Smartlink Network Systems Ltd. accepts no responsibility for loss or damage arising from the use of the information transmitted by this email including damage from virus.
This email has been scrubbed for your protection by SecureMX.
For more information visit http://securemx.in