Hello once again,
Is there a way to get "normal" scanning from an AP, with a list of found APs
available after the netlink message? The current behaviour seems to be that
the AP scans and settles on some suitable frequency. I don't want to change
the frequency, I just want to gather information.
Is there any way to set up nodes in a way that they find each other with a
scan (and report that data instead of just silently dumping it!) and end up
in the same state they started it?
Alternatively: it seems that the scan interfaces for AP and STA scans are
fairly similar, but the AP has even longer dwell times. Does it work to just
copy the data keeping mechanisms from the STA scan over to the AP scan so
that they are cached and reported back, and to just remember the channel
before scanning and make the channel picking in ap_end just use that channel
It is not necessary that this produces APs fit for serving their original
purpose, I am just after the scan visibility and predictability mentioned
before. Also, I am starting to run out of time and would really appreciate
some input from people who know their way around that part of the driver.
Thanks in advance.