Confirm the sensor you are using.
Just open your .csr file and read it at beginning.
Double check that it is really this one your windows driver is using!
>>can you please give me some suggestions or comments why i am receiving a
pattern (see .jpg) that keep on running but no picture on my webcam
There is really no way to use m5602 with m5603c chip. If you move something in
front of the cam, your picture must move in sync. If not the, the data is not
from then cam!
Then try with those ones from my cam.
Warning: the microcode is loaded one time until the cam is turned off.
Send me yours also.
Compile and use pixfmt_test.!!!
and use 'make'.