Problem setting up lirc

[Florian L. <mai...@xg...>]

Hello,
I'm using a IR receiver from a DVB-T box:

usb 1-3.3: new high speed USB device using ehci_hcd and address 9
usb 1-3.3: configuration #1 chosen from 1 choice
dvb-usb: found a 'AVerMedia AverTV DVB-T USB 2.0 (A800)' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software=20
demuxer.
DVB: registering new adapter (AVerMedia AverTV DVB-T USB 2.0 (A800)).
dib3000: Found a DiBcom 3000P.
DVB: registering frontend 0 (DiBcom 3000P/M-C DVB-T)...
input: IR-receiver inside an USB DVB receiver as /class/input/input6
dvb-usb: schedule remote query interval to 150 msecs.
dvb-usb: AVerMedia AverTV DVB-T USB 2.0 (A800) successfully initialized and=
=20
connected.

I've compiled lirc 0.8.0 with the devinput driver using a Gentoo ebuild and=
=20
used the config file from=20
http://lirc.sourceforge.net/remotes/avermedia/lircd.conf.RM-FP and copied=20
to /etc/lircd.conf without any modification

The IR controller sends messages to /dev/input/event4:

horus florian # cat /dev/input/event4
D2E3tD2E3tD2E3F2E=CA=84
                  F2E=CF=84
                      F2E=D1=84

(after pressing some buttons on the remote control).

lircd starts up fine:

lircd-0.8.0[10802]: lircd(devinput) ready

but I only see a /dev/lircd device (using udev).=20

horus florian # cat /dev/lircd
cat: /dev/lircd: No such device or address

I wonder if there is no possibility to set the the source of the commands=20
(e.g. /dev/input/event4)
What is wrong with my config?

Thanks,

=46lorian