I am using LIRC to control home theater components.
How do I adjust the repeat speed for press-and-hold IR commands?
#irsend SEND_START amp Vol_UP
The repeats work, but the volume ramp is slower than when using the
factory remote to control the amp's volume.
(The example below is learned from the remote, but I have a similar
issue with repeat speed for a config file I downloaded from
sourceforge for a cable box.)
Apologies if this topic has been covered already (couldn't find a
thread on this).
Thanks in advance for your help!
# cat lircd.conf
header 9014 4480
one 549 1657
zero 549 530
begin codes # partial listing