I have a remote here that control my A/C (Made by Haier). You can see
the remote at http://us.st11.yimg.com/us.st.yimg.com/I/giladbarlev_1897_124091.
I have successfully created a lirc.conf using irrecord -f -d
-/dev/lirc0 but the file seem to differ from the one I have seen in
the generic remote folder for example. It only contain "raw_codes" as
opposed to "codes". When I reload ircd with the proper file, irw
report nothing ( I was able to make irw spit something with another
remote/config). Is there a way to create those code from the
raw_codes or is there something I am missing?
Note: attached the lirc.conf
Also, what should I use once I am able to catch the signal, to send
the same signal using my IR Blaster?
Thanx a lot
Martin Gingras Eng.