From: <col...@hi...> - 2002-01-19 22:04:00
|
Hi, I've uploaded lirc-0.6.5pre2 to http://www.lirc.org/software/snapshots/. This is a release candidate, so please test it. Christoph |
From: Boris <bo...@ce...> - 2002-01-20 17:18:29
|
Dne 19 Jan 2002 20:43:00 GMT col...@hi... (Christoph Bartelmus) napsal/a: > Hi, > > I've uploaded lirc-0.6.5pre2 to http://www.lirc.org/software/snapshots/. > This is a release candidate, so please test it. > Seems to work perfectly, just some notes: - in INSTALL should be that I have to run ./setup.sh ant then ./configure ... (as in doc/html/install.html) - when running ./setup.sh, in Mainmenu, after selecting 2 Soft. conf., I choose what I want, OK, highlighted is again 1 Driver conf.... - it probably should be 2 Soft. conf - As I wrote about month ago: In the docs should be noted, that you cannot test lirc with mode2 while running lircmd (otherwise it would say: mode2: error opening /dev/lirc mode2: Device or resource busy) The only thing that doesn't work is running it under X(v. 4.0.3) and console at the same time (but I don't need it - and if I switch to console I can run gpm -k gpm -t imps2 -R -M -m /dev/lircm -t ms3 and before return to X gpm -k gpm -t imps2 -m /dev/psaux) Just one question - is it possibe/planned to use wheel option with lircmd? Thanks BzF > Christoph |
From: Nerijus B. <ne...@us...> - 2002-01-20 20:30:14
|
On 19 Jan 2002 20:43:00 GMT Christoph Bartelmus <col...@hi...> wrote: CB> I've uploaded lirc-0.6.5pre2 to http://www.lirc.org/software/snapshots/. CB> This is a release candidate, so please test it. I have a problem running configure with latest cvs: ... checking vga.h presence... yes checking for vga.h... yes ./configure: line 8667: syntax error near unexpected token `yes:no' ./configure: line 8667: ` yes:no' Please read the documentation!!! I have libtool-1.4.2, automake-1.5 and autoconf-2.52. Are these going to be supported? Regards, Nerijus |
From: <col...@hi...> - 2002-01-22 20:24:41
|
Hi! Boris "bo...@ce..." wrote: [...] > - in INSTALL should be that I have to run ./setup.sh ant then > ./configure ... (as in doc/html/install.html) Done. > - when running ./setup.sh, in Mainmenu, after selecting 2 Soft. conf., > I choose what I want, OK, highlighted is again 1 Driver conf.... - it > probably should be 2 Soft. conf dialog would have to be modified, I think. > - As I wrote about month ago: > In the docs should be noted, that you cannot test lirc with mode2 while > running lircmd (otherwise it would say: mode2: error opening /dev/lirc > mode2: Device or resource busy) I'll rather make this a FAQ. The error message actually should be helpful. [...] > Just one question - is it possibe/planned to use wheel option with > lircmd? Yes, the IntelliMouse and IMPS/2 (using the latter is deprecated) have wheel support. Christoph |