Juan many thanks for your suggestion and your work,

after configure the remote control buttons, my remote control now work. :)

But i have a little problem again, i used this command for active the remote control :

sudo /usr/bin/ir-keytable -p NEC,RC6 -w /etc/rc_keymaps/rc6_mce

Every time that i reboot, i must run the above command. This is a malfunction or just set the startup command?

Best regards,

Lino Fantasia

2011/7/31 Juan Jesús García de Soria Lucena <skandalfo@gmail.com>

Hi, Lino,

You shouldn't need to configure lirc itself, since the driver in kernel 3.0 should be usable directly as an input device.

The ps -ef | grep lirc you did doesn't show the lircd daemon running, just the grep you were using to find the former one. So I guess you didn't get the lirc userspace properly activated anyway.

This link might give you some info about the new ir-keytable interface for managing remotes:

http://forum.xbmc.org/showthread.php?t=101151

Best regards,

    Juan Jesús.

:wq

El 31/07/2011 17:57, "Lino Fantasia" <linofantasia@gmail.com> escribió: