Re: [Jsynthlib-devel] Converters Not Working

[Jeff W. <jww...@ya...>]

Hiroo,
 
You can go into preferences and configure any device/driver, even if you don't have the actual physical device. All I'm testing is the Get... command under the Patch menu. I just want to see if the "Get Sysex Data" dialog comes up. You don't need any actual sysex data for that. Here's what I did:
 
1. Go into preferences/synths and remove all devices.
2. Add a device that uses a converter. Any of them will do.
3. Quit the program and restart.
4. Click on Patch menu and select Get...
Does the "Get Sysex Data" dialog appear?
 
In step 1 & 2, if you don't want to remove all devices, add any of the devices that use a converter and that have a name that appears alphabetically ahead of any of the other devices you have configured.
 
The quit and restart in step 3 is there to allow the device list to sort properly before you try the actual test. I found one case where this made a difference.
 
Thanks,
Jeff
 

Hiroo Hayashi <hir...@co...> wrote:
Jeff,

How can I reproduce this problem?
In other words, how can I test converter without having synth nor sysex
data being imported?

Jeff> device/driver at a time. The same NullPointerException
Jeff> occurs on all of the ones I tested. I tested the
Jeff> following devices, quitting and restarting the program
Jeff> and cleaning out the config between each test:
Jeff> Yamaha TG100
Jeff> Kawai K4
Jeff> Yamaha DX7
Jeff> Korg X3 (this one has two converters)
Jeff> Yamaha FS1R

-- 
Hiroo Hayashi


		
---------------------------------
Do you Yahoo!?
Yahoo! Mail Address AutoComplete - You start. We finish.