Re: [Gumstix-users] Brand new Parlor/DuoVero is dead

[ezex <pel...@gm...>]

Hi,  i have some NEWS.

1) I used Sakoman images and script to create the images for my Duovero
Gumstix
http://feeds.sakoman.com/feeds/yocto-1.3/images/omap4-multi/current/
and the script  mksdcard.sh
using this commnand line:
 sudo ./mksdcard.sh /dev/mmcblk0 duovero xfce current

Whit this, I have good Image, and NOW I CAN GET   console output on the
duovero 
(this board doesn't have NAND, so it needs a valid microSD and image boot,
to output console)

2) After this,   ALL MY BOOTS HANGS  HERE
ALSA device list: 
  #0: duovero 
  #1: OMAPHDMI 
Waiting for root device /dev/mmcblk0p2...


3) SOLVED, AFTER TRYING MANY IMAGES (was not the problem)  I read on this
link :
http://www.mentby.com/Group/gumstix-users/duovero-images.html

tha some duo vero, have a FAULTY MICROSD CONNECTORS.  and pressing on the
middle , ALL BOOTED UP, while pressing the simcard tray connector.
After a little bit of experimenting: if it stops at the "Waiting for 
root device "-message and you push just at the right spot (center of the 
label with the serial number), the filesystem is found and the system 
continues to boot. Perhaps the kernel uses another method to access the 
data on the card with stricter timing requirements than the first boot 
stages (just guessing).

I HAVE TO SEND IT BACK, is defective.



--
View this message in context: http://gumstix.8.x6.nabble.com/Brand-new-Parlor-DuoVero-is-dead-tp4966900p4967452.html
Sent from the Gumstix mailing list archive at Nabble.com.