Re: [Gumstix-users] linux network/CF problem

[Chris D. <chr...@gm...>]

Hi Opher,

A couple of questions:
What buildroot release is on your gumstix? (cat /etc/gumstix-release)
What modules are loaded on your gumstix (lsmod)
How is your CF card formatted?  I think only FAT is supported out-of-the-box...

Chris

On 11/27/07, Opher Gazith <op...@to...> wrote:
>
>
> Hi All
>
> I'm new in with linux and gumstix. I tryed to run the system of verdex XM4
> with extantion netCF-vx and serial ports console-vx. from the startup I
> should get the network get IP address from the DHCP server. nothing is
> happened and when I try ping I got the following error : PING 192.168.1.1
> (192.168.1.1): 56 data bytes
> ping: sendto: Network is unreachable
>
> trying to restart the network with ifconfig eth0 down, and then ifconfig
> eth0 up will get a result : eth0: link down
> ADDRCONF(NETDEV_UP): eth0: link is not ready
>
> the port on the switch is active and not active with the command up and
> down.
>
> also when I type df I get only the flash disk on baord and not the 1GB CF
> card I have put.
>
> in modules file I update the file to have CF support
> # MMC support -- comment out the next two lines to enable CF
> #mmc_block
> #pxamci
>
> # Compact Flash support -- Must load smc91x first!!
> smc91x
> pcmcia
>
>
> please help
>
> Opher Gazith
> -------------------------------------------------------------------------
> This SF.net email is sponsored by: Microsoft
> Defy all challenges. Microsoft(R) Visual Studio 2005.
> http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
> _______________________________________________
> gumstix-users mailing list
> gum...@li...
> https://lists.sourceforge.net/lists/listinfo/gumstix-users
>
>