From: Doyle, Patrick <Patrick_D<oyle@dt...> - 2006-06-26 21:52:33
Off hand, I would say it sounds like a power problem -- when you dial in 100
for the mixer output, it should (in theory) draw more power than dialing in
80 or so.
In theory, there is no difference between theory and practice.
In practice, there is.
> -----Original Message-----
> From: Mark Yatskar [mailto:myatskar@...]
> Sent: Friday, June 23, 2006 6:53 PM
> To: General mailing list for gumstix users.
> Subject: [Gumstix-users] Problems with aumix
> Hey guys,
> Just as a note, i've been fiddeling with making a sound
> player for the gumstix using the /dev/dsp driver. I've run
> into the following problem: if i set the mixer output to 100
> : aumix -v 100, the audio output completely fails and I can't
> get any output at all (to be precise it fails after an
> inconsistent amount of time, 1 sec, 10 sec but never more
> than a little). I have to reboot the gumstix in order to get
> anything to play again. If I set the volume to lower, say
> aumix -v 80, no problem and no shut outs. If I keep it at 80,
> I simply don't have problems.
> Just thought you guys should know, if you have any comments....