I am trying to use a Verdex Pro + Robostix combination. I am trying to use
the gumstix to program the robostix, so I am following the instructions in
http://docwiki.gumstix.com/index.php/Robostix_gumstix_ISP (but using OE to
bitbake and stuff).
The robostix module loads in the gumstix module fine. The problem is when I
type "uisp" it gives me this error:
Probably the AVR MCU is not in the RESET state. Check it out and run me
The wiki says it could be because the jumpers are not installed, but they
are. I also powered the robostix directly.
Could this be a fuse problem?
View this message in context: http://old.nabble.com/Robostix-UISP-problem-tp26635789p26635789.html
Sent from the Gumstix mailing list archive at Nabble.com.