Dear all,

(apologies for possible duplication. couldn't find anything about this on the archives tough)

I am trying to go down this tutorial http://wiki.gumstix.org/index.php?title=Caspa_camera_boards .
I got a booting kernel but then this output is shown:

//--------------------------------------
Waiting for root device /dev/mmcblk0p2...
mmc0: host does not support reading read-only switch. assuming write-enable.
mmc0: new high speed SDHC card at address 0001
mmcblk0: mmc0:0001 00000 7.60 GiB
 mmcblk0: p1 p2
kjournald starting.  Commit interval 5 seconds
EXT3-fs (mmcblk0p2): using internal journal
EXT3-fs (mmcblk0p2): mounted filesystem with writeback data mode
VFS: Mounted root (ext3 filesystem) on device 179:2.
devtmpfs: error mounting -2
Freeing init memory: 940K
Kernel panic - not syncing: No init found.  Try passing init= option to kernel. See Linux Documentation/init.txt for guidance.
--------------------------------------//

I've seen here http://www.gumstix.org/create-a-bootable-microsd-card.html that an MLO and an u-boot.bin files are needed. As those are not provided I'm not putting them in the SDcard.

Does any of you have a suggestion for this?

Thanks in advance,
gonber