Hello all,

Sorry if this is a simple question, but I just wanted to verify something as I am working on a robotics research project and I have never worked with computer hardware enough to be confident.

On the gallup43 board, it says it has 6 PWM lines. I would be under the assumption that these could control servos after soldering some 3 pin male connectors. It looks like their are a row  two joints on the side of the board for the PWM lines (and other stuff) and the third just gets grounded.

I just wanted to make sure that my assumption of using the PWMs to control servos is correct.


Thanks for the help,
Karl